ÖNORM EN 17059

This document describes all significant hazards, hazardous situations and events relating to plating and anodizing lines, when used as intended and in compliance with the foreseeable conditions of the manufacturer. In addition, procedures for testing and measuring safety requirements, marking of equipment and minimum operation requirements are specified. For reference to plating lines and anodizing lines the term plating line is used in this document. This document applies to the design and construction of plating lines and anodizing lines including their transporter systems for surface treatment of industrial products by means of inorganic or organic electrolytes or by means of other process chemistries. Plating lines and anodizing lines in terms of this standard are arrangements of process tanks for: - electrolytic treatment of work pieces (e.g. electrocleaning, passivation, electroetching, burnishing, electrolytic polishing and brightening, drying); - wet chemical treatment of work pieces (e.g. degreasing, passivation, chemical polishing, etching, pickling, blackening); - electrolytic and electro-less metal deposition, even on non-metallic work pieces made electrically conductive by corresponding treatment; - changing of substance composition on the surface of metallic work pieces e.g. burnishing, blackening, phosphatizing, chromating and; - anodizing (anodic oxidation); including rinsing tanks and the corresponding transporter equipment (e.g. transporter systems, handling gantry, bean, etc.), where the products are lifted in and out of tanks.