ÖNORM EN 14015

1.1 This document specifies the requirements for the materials, design, fabrication, erection, testing and inspection of site built, vertical, cylindrical, flat bottomed, above ground, welded, steel tanks for the storage of liquids at ambient temperatures and above, and the technical agreements that need to be reached (see Annex A). This document does not apply to tanks where the product is refrigerated to maintain it as a liquid at atmospheric pressure (see prEN 14620). This document is concerned with the structural integrity of the basic tank structure and does not provide requirements for considering process design, operational issues, safety and firefighting facilities, in-service inspection, maintenance or repair. These aspects are covered in detail in other Codes of Practice (see Annex B). 1.2 This document applies to closed-top tanks, with and without internal floating covers (see Annex C) and open-top tanks, with and without floating roofs (see Annexes D and E). It does not apply to lift-type gas holders. 1.3 This document applies to storage tanks with the following characteristics: a) design pressure less than 500 mbar1) and design internal negative pressure not lower than 20 mbar (see 5.1 for pressure limitations); b) design metal temperature not lower than -40 °C and not higher than +300 °C (see 5.2.2); c) maximum design liquid level not higher than the top of the cylindrical shell. 1.4 The limits of application of this document terminate at the following locations. face of the first flange in a bolted flange connection; first threaded joint on the pipe or coupling outside of the tank shell, roof or bottom; first circumferential joint in a pipe not having a flange connection. 1.5 This document is applicable to steel tanks with a maximum design strength <= 260 N/mm2.