ÖNORM EN 10210-1

This document specifies technical delivery conditions for hot-finished seamless, electric welded and submerged arc welded steel structural hollow sections of circular, square, rectangular or elliptical forms. It applies to hollow sections formed hot, with or without subsequent heat treatment, or formed cold with subsequent heat treatment above 580 °C to obtain equivalent mechanical properties to those obtained in the hot formed product. NOTE 1 The requirements for tolerances, dimensions and sectional properties are specified in EN 10210-2. NOTE 2 The provisions that apply under the Construction Products Regulations (CPR) are specified in EN 10380. NOTE 3 The attention of users is drawn to the fact that whilst cold formed grades in EN 10219-1 can have equivalent mechanical properties to hot-finished grades in this document the sectional properties of square and rectangular hollow sections in EN 10210-2 and EN 10219-2 are not equivalent. NOTE 4 A range of material grades is specified in this standard and the user should select the grade most appropriate to the intended use and service conditions. The grades and mechanical properties of the finished hollow sections are generally comparable with those in EN 10025-2, EN 10025-3, EN 10025-4, EN 10025-5 and EN 10025-6. NOTE 5 The requirements for seamless and welded steel structural hollow sections for use in offshore structures are covered in EN 10225. NOTE 6 Spiral welded hollow sections must be used with caution in applications involving dynamic behaviour (fatigue stress) as, up to now, there is insufficient data regarding their performance.