Please select and order
€120.67
excl. VAT
Add to cart
Norm
ÖNORM EN 17415-1
Issue date: 2021 02 15
District cooling pipes - Bonded single pipe systems for directly buried cold water networks - Part 1: Factory made pipe assembly of steel or plastic service pipe, polyurethane thermal insulation and a casing of polyethylene
This document specifies requirements, design and test methods for straight lengths of factory made thermally insulated pipe-in-pipe assemblies for directly buried distric...
Valid
Publisher:
Austrian Standards International
Format:
Digital | 45 Pages
Language:
German
| English
| Download GER/ENG
Optionally co-design standards:
ICS
This document specifies requirements, design and test methods for straight lengths of factory made thermally insulated pipe-in-pipe assemblies for directly buried district cooling distribution systems, comprising a service pipe from DN 15 to DN 1200, rigid polyurethane foam insulation and a casing of polyethylene. The pipe assembly can also include the following additional elements: measuring wires, spacers and diffusion barriers.
This document applies only to insulated pipe assemblies, for continuous operation with water at various temperatures (1 to 30) °C and a maximum operation pressure of 25 bar.
The design is based on an expected service life with continuous operation of a minimum 50 years.
ÖNORM EN 17415-1
2021 02 15
District cooling pipes - Bonded single pipe systems for directly buried cold water networks - Part 1...
Norm
↖
Norm
Issue date :
2019 02 27
Polyolefin pipes and fittings — Determination of carbon black content by calcination and pyrolysis — Test method
Norm
Issue date :
2009 01 29
Plastics pipes and fittings — Preparation of polyethylene (PE) pipe/pipe or pipe/fitting test piece assemblies by butt fusion
Norm
Issue date :
2001 10 25
Polyethylene (PE) pipes and fittings — Determination of the tensile strength and failure mode of test pieces from a butt-fused joint
Norm
Issue date :
2019 09 25
Plastics — Determination of environmental stress cracking (ESC) of polyethylene — Full-notch creep test (FNCT)
Norm
Issue date :
2002 03 28
Method for the assessment of the degree of pigment or carbon black dispersion in polyolefin pipes, fittings and compounds
